How to Build a Cable TV System in Building/Home

by:APTEK     2020-08-08
Installing a cable TV system need not be difficult, it will become easy and convenient when you have the right and good quality products eb-ce is offering you the good quality products for cable TV System. As conventional coaxial splitters and amplifiers work exceptionally well. Remember, when the cable length is increasing the signal output will decrease accordingly. Firstly we need to decide how many cable TV homes to be connected with the splitter or amplifier then to put the proper amplifier into the cable TV line and try to deliver at least 57dbuv signal level. The distribution of RG-6 is not complex and since this type of cable will happily carry television, data and digital content with an enormous amount of bandwidth simultaneously makes the idea very attractive. Instructions 1. Step 1 Select a central logical location to mount a high-bandwidth splitter or distribution block. Screw this device down to a secure spot using the drill. 2. Step 2 Determine the individual locations desired for cable entry. In most cases, cable terminations are wall plates in the individual spaces. Using the coax cutters, cut a sufficient amount to reach from a space to the distribution location. 3. Step 3 Strip off 1/4-inch of insulation from one end of the coax using the coax stripper. Place the stripper over the end of the wire, squeeze and rotate the stripper around the cable until it spins freely. Pull off the cut jacketing from the cable. Fold the shielding back against the jacket. Push the connector onto the end of the now-exposed wire as far as it will go. Place the coax crimper over the collar of the connector, squeezing the handles until they are secure. 4. Step 4 Repeat the stripping and termination process for all coax cable ends designated for connection to the splitter. Screw on the connectors to the output legs in a clockwise motion, until they are fully seated. 5. Step 5 Drill a hole through the baseboard into the access area where the splitter is located. The bit should penetrate through the footer and into the access area. Remove the bit from the hole. 6. Step 6 Locate the small hole the 3/16-inch bit created in the footer. In the access space, take the 1-inch bit and drill straight up through the footer, immediately adjacent to the smaller hole. Drill a 2-inch hole directly above the hole made behind the baseboard, at the same height as other outlets. Repeat these steps for each room designated for coax wiring. 7. Step 7 Grab the fish tape in the access area. Bring the end of the coax cable parallel to the end of the fish tape, wrapping a few tight turns of the electrical tape around both. Push the tape back through the footer and through the 2-inch hole in the wall. 8. Step 8 Un- wrap the tape, freeing the coax. Terminate the coax as detailed in the access room. Screw on the connector to the rear of the coax plate and screw the plate to the wall using two wood screws and the drill with a Philips bit. Step 9 When the installation is completed, check the CATV signals through Maxpeak Cable Meter ensure that all the channels are in good picture quality and C/N ratio.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
Hello, please leave your name and email here before chat online so that we won't miss your message and contact you smoothly.