Cable connector installation steps
< p > cable connector before installation should check the required tools should be documented and in good condition. < / p > < / p > < p > cable connector installation steps of the specific as follows: < / p > < p > 1, remove the cable connector, removable partial order apart; < / p > < p > 2, to end is fixed, the cable on the shaft on a board, end - 200 mm 300 mm, end downward sloping and horizontal direction into 30 ° - About 45 ° Angle; < / p > < p > 3, use hand saw or electrician knife strip for a period of about 45 mm long cable sheath, cross section requires flat; < / p > < p > 4, with sealant in the surface of the sheath and outer conductor junction; < / p > < p > 5, with copper brush will remain in the sheath of cable head clear out powder, copper scrap, etc; < / p > < p > 6, water cutting pliers, file, emery cloth, Angle, light tools such as burr. < / p >
Whenever the question of PRODUCT custom cable assemblies is raised, one comes across the term ''.
The best way to confront your custom cable assemblies problem is to search for a high quality offered by Zhongshan Aptek Electronics Technology Co.,Ltd at APTEK. Take a look!
According to the latest social survey, more than 50 percent of consumers (across all age demographics) follow a brand before purchasing a product. Therefore, APTEK's content can make or break a customer's decision to conduct business with you.