How to Replace Fragile Parts of Sand Maker
The sand maker is used in crushing soft or medium hard and extremely hard materials, shape and widely used in a variety of ores, cement, refractories, alumina bauxite, carborundum, glass raw materials, stone of mechanisms construction and the gold slag.
When you replace the fragile parts, ensure that the device is in shutdown state which means is not the work of the state to open the back of the shelves, and then bolt Remove the shelves and in the box junction, and then use the wrench to unscrew the clamshell device hex head part of the shelves will slowly open. The rack above the hanging device of rear rack.Repeat the above process, the closed shelves. Sand the board hammer: counter broken boards hammer wear to a certain extent should be timely adjustment or change in order to avoid the damage of fasteners and other components. Sand liner: Open shelters, demolition of a fixed fight back liner ashamed pin, slotted nut, bolt, you can counterattack liner change after the wear and tear, such as installing a new liner.
The Brief introduction of Sand Making Machine: Novel and distinctive design. Simple and reasonable structure. Smooth operation and low operating cost. Two states of 'stone hitting stone' and 'stone hitting iron' can be changed freely. The sand making machine equipment can be applied to manufacturing sand as crushing stones. The 'stone hitting stone' technology not only reduces parts friction but also cuts down manufacturing cost. Low energy consuming, high yield, large breaking proportion and energy save. The equipment is capable of shaping out products. Products take a cubic shape and enjoy high bulk density. During the manufacturing, stone materials can form a protective bottom to avoid wearing the equipment, so the equipment is durable in use. Few abrasive parts are made of wearing resistant material of special hardness, which is small in volume, low in weight and easy to be changed. Automatic air circulatory system can purify concentrative screening powder. Water content of the material exerts little influence, and maximum contenting water can be 8%. Lubrication oil station is adopted to lubricate the major bearing in circulation to ensure a constant oil supply. It can realize automatic control and accident alert. The upper is uplifted by hydraulic system, and operation is simple.
Sand maker : http://www.crusher-export.com/sand_maker.htm