The composition and use the cable connector
< p > the structure of the cable connector: < / p > < p > cable connector plug part and socket parts respectively two main body parts. < / p > < p > socket components are installed on the machine or other need for 10 kv ac voltage and current under 500 a and device, a plug part and cables after installation, conductive via three connection rod inserted into the socket, will feed input shall provide the power supply device. With two other plug connected component cable connection between the coupling effect, plug parts and cables after installation, must use special cold epoxy resin casting agent filler filling of cavity space inside the plug, to solidify rear can use. < / p > < / p > < p > cable connector use note: < / p > < p > 1, the cable connector to use when had better not choose a rainy day, because the cable into the water will seriously affect the service life of the cable, serious can appear even short circuit accident; < / p > < p > 2, copper tube can not be too hard, suppress as long as the pressure from a can; < / p > < p > 3, heat shrinkable cable joint, when using a blowtorch, pay attention to the torch moving back and forth, not only to a direction for the fire, the size of the cold cable joint must be in strict accordance with the drawings to do, especially take out the reserved in the tube support, more careful operation. < / p > < p > < / p >
Zhongshan Aptek Electronics Technology Co.,Ltd are maintaining a consistent bottom-line profit and that you've shown steady growth over the past few years.
There is always a question of how to custom cable assemblies, but have you ever thought about the price point? Go to APTEK to get cost effective offer.
PRODUCT has a very good repute over the global market.